Flow of ring-making experience ① ~ Choose what to make ~

Hello 🌱

We are looking back on past blogs today as well.

This time is about the article "Step by Step Handmade Ring ♪" written in June 2020 ♪

This article describes the flow up  when you come to experience ring texturing.

If you have made a reservation for the ring-making experience or are considering it, please click the URL at the bottom of this article and read the past blog.

Also, because the article was written a few months after our Osaka shop was opened, the products which we handled as well as the prices at the time are different from the present .

◎ About the material written in step 1 in the article

It was only silver and gold, but now we also handle platinum.

◎ In step 2 "Let's decide the width of the ring"

"Silver is 1.0mm-3.0mm, Gold is 1.0mm-2.5mm"

However, the lineup has now increased for Silver 1mm-4mm and for Gold 1mm-3mm.

◎ In step 5 "Let's consider options"

The processing cost of the combination ring of K10 x K10, K18 x K18, and K18 x platinum was 4000 yen (tax excluded), but now it is 5,500 yen (tax included).

In addition to the above, as a product lineup, a wide type silver ring, which is limited for orders only, and a service to embed diamonds onto the surface of the rings made at our shop have also been added in the last two years.

Through the blog, I realized that our shop has changed little by little by listening to the voices of customers and the passage of time 😀

Thank you for your valuable opinions and impressions.

We will continue to listen to the voices of our customers while conducting business.

Past article (2020.06.05) "Step by step" handmade ring ♪ 

https://itoaware-osaka.storeinfo.jp/posts/8365875?categoryIds=3002325